Question about hole callout on slot : rSolidWorks

Counterbore Symbol

Question about hole callout on slot : rSolidWorks Apply a hole callout to a hole or thread, automatically inserting the metadata of the hole or thread

Counterbore Symbol

slot betting or if not, what is a better way to make the callout? Should I lay a center mark on the curved slot center, give it a radius dimension,

While creating a hole using the Hole tool, you can also apply a hole callout to A counterbore hole is a stepped hole and has two diameters, a bigger

counterbore slot callout Block 1 Start with a block primative Then add the counterbore hole; Next add a boss with a draft angle to create the

How Are Spotfaces Shown on Drawings? An example of a spotface is shown below, the dimensioning is very similar to a counterbore Spotface Engineering Drawing